• Please read all instructions before installing.
• Follow all instructions carefully. Failure to install or use this product in accordance with the enclosed instructions will void your warranty.
• Verify that all operating switches are in the OFF position before installation.
• For any questions or problems with you ElectraView screen, please contact your dealer or Hurley Screen.

• When hanging case, ensure that all mounting hardware is securely attached to solid structural support or members. (Overhead beams or rafters for suspended installation, studs or other structural support for wall installation).
  
  
• If screen is not hung level, the material will not roll up correctly and will wrinkle.
  
  

  Suspended by Chain: the screen can be hung by placing the enclosed S-hooks through the holes at the end of the case. Attach chains to a beam or other structural member, then attach the S-hooks to the chain. use turnbuckles to ensure that the screen is hung level. Each turnbuckle and chain must be rated to lift 75 bs.

  Recessed in Ceiling: when mounting the screen in a recess, shown here using All Thread, make sure the opening is constructed to fit the screen case.

  Wall Mounted: screw the screen case into place through the hols in the back of the end caps. Use toggle bolts, molly bolts, nylon or lead anchors if needed. (Hurley recommends usuing #12 srews/lags or bolts or larger).

Click here for a printable version of this page: