Products > ElectraView > Focus > Operating Instructions
ElectraViewTM Focus Models "S" and "T"
- Please read all instructions before installing.
- Follow all instructions carefully. Failure to install or use this product in accordance with the enclosed instructions will void your warranty.
- Verify that all operating switches are in the OFF position before installation.
- For any questions or problems with you
ElectraView screen, please contact your dealer or Hurley Screen.
Operating Instructions
Hurley Screen recommends using a licensed electrician to do any and all electrical connections.
- All operating switches should be in the OFF position before power is connected.
- Screen motor operates on 110-120V, 60hz. AC current.
- Junction box is located on the right end of the screen's case and contains the terminal strip as illustrated in the enclosed wiring diagram. The switch should be connected as illustrated in the wiring diagram.The switch included with your screen will be one of the following types:
1. Single Location Switch: This switch has 3 positions, UP, OFF and DOWN. Operation of the screen can be stopped and restarted at any point.
2. Multiple Location Switches: These switches allow the screen to be controlled by more that one switch.
3. Key Operated Switch: This 3 position switch requires the screen operator to use a key to operate the screen.
- Allow two minutes between raising and lowering screen.
Adjustments
This screen has been set at the factory to the correct stopping positions. To change these positions:
- Be sure all control switches are in the OFF position
- To adjust the retracted position of the screen: Adjust the retracted position by resetting the white limit switch on the right end of the roller tube, inside the screen case. Remove the limit switch cover on the motor. By pressing the white button, the retracted position is released. Retract the screen to the new fully retracted position using the control switch. When set, press the white button again, which will set the new retracted position. Check by raising and lowering the screen. If set correctly, replace the limit switch cover.
- To adjust the fully-lowered position of the screen: Follow the instructions above, but using the yellow limit switch on the right end of the roller tube.
Also, review the installation or wiring instructions for the Focus Model "S" and "T".
Click here for a printable version of this page:
HURLEY SCREEN . 110 Industry Lane . Post Office Box 296 . Forest Hill, MD 21050
Tel: 410.879.3022 - Toll Free: 877-487-4912 - Fax: 410.838.8079
| 
