Products > ElectraView > Vision > Operating Instructions
ElectraViewTM Vision Models "S" and "T"
- Please read all instructions before installing.
- Follow all instructions carefully. Failure to install or use this product in accordance with the enclosed instructions will void your warranty.
- Verify that all operating switches are in the OFF position before installation.
- For any questions or problems with you
ElectraView screen, please contact your dealer or Hurley Screen.
Operating Instructions
Hurley Screen recommends using a licensed electrician to do any and all electrical connections.
- All operating switches should be in the OFF position before power is connected.
- Screen motor operates on 110-120V, 60hz. AC current.
- Junction box is located on the right end of the screen's case and contains the terminal strip as illustrated in the enclosed wiring diagram. The switch should be connected as illustrated in the wiring diagram.
The switch included with your screen will be one of the following types:
1. Single Location Switch: This switch has 3 positions, UP, OFF and DOWN. Operation of the screen can be stopped and restarted at any point.
2. Multiple location Switches: These switches allow the screen to be controlled by more that one switch.
3. Key Operated Switch: This 3 position switch requires the screen operator to use a key to operate the screen.
- Allow two minutes between raising and lowering screen.
Adjustments
This screen has been set at the factory to the correct stopping positions. To change these positions:
| 
